Loading the content...

Gas Lift

Return to Previous Page

Product Description

  • produce wells that do not flow naturally
  • increase production of a flowing well
  • kickoff or unload a well that will later flow naturally
  • keep gas wells from loading by either intermittent or continuous flow gas lift
  • lift wells with deviated and horizontal wellbores
  • ability to handle changing well conditions
  • low cost of initial downhole equipment
  • production rates can be controlled at the surface
  • sand or solids production has no effect on gas lift equipment
Gas Lift Valves
  • conventional
  • wireline retrievable
Gas Lift Mandrels
  • AISI 4130 or 13 CR
  • conventional
  • sidepocket
Check Valves
  • conventional
  • reverse flow
Wireline Retrievable Latches
  • BK-2 Latch
  • RK Latch

Related Products

Gasmaker Cleanout Plunger Quick View

GasMaker CleanOut Plunger

pdfdwn-a-64Excellent for paraffin, sand, scale and solids removal.  
Rapid Drop Plunger Quick View

The Rapid Drop Plunger

pdfdwn-a-64 Designed to fall at high speeds, similar to a PaceMaker, but does not require as much flow time at surface to separate a secondary piece.  This tool is designed as an intermediate step between PaceMaker candidate wells and Conventional Plunger candidiate wells. The Rapid Drop Plunger requires no additional equipment on surface to adapt the well for this application and can run in wells with existing subsurface equipment. These plungers are built with heat treated steel.  It is recommended that the Bottom Hole Spring have a spring rate of at least 300lbs per inch to handle dry landings.
Quick View

GasMaker Multi Stage Plunger

The PIT Multi-Stage Plunger system increases gas and liquids production by staging the well.  This is done by moving part of your energy source under each stage.  By staging the well, the fluid load is lifted to a shallower depth.
GasMaker Ultraseal Plunger Quick View

GasMaker Ultra Seal Plungers

pdfdwn-a-64 The Ultraseal Plunger has a HNBR rubber Ultra Seal attached to the body of the plunger between interlocking tabs under the pads. The interlocking pads serve as a protector to the Ultra Seal which decreases gas slippage under the pads. This results in less fluid "fallback" during the plunger cycle to the surface, which allows the plunger to make a run on less gas pressure. Offered in single or dual pad design.