Showing all 11 results
Invented and patented by Premier Integrated Technologies, the MagLock Plunger puts conventional seal methods to shame. The MagLock plunger is a shift valve style plunger. While regular plungers use Snap Rings, D-Tent Bulbs, or springs to hold the shift valve closed, the MagLock Plunger utilizes powerful earth magnets to form the ultimate seal.
Industry leading solution for liquid loaded horizontal well applications. The PIT PaceMaker Plunger Lift System utilizes a proven, patented, two-piece plunger design. The large bypass area of the plunger, coupled with high strength materials and other proprietary system components, allows production companies to increase production and recoverable reserves. Plunger and ball combos are available in titanium, steel and other specialty materials. Fluid and gas rates determine plunger length and weight requirements.
PIT offers an economical, high performance, pad-style plunger. These plungers implement three spring-loaded pads per section and wear less due to a single piece mandrel. Very efficient sealing plunger.
The PIT Multi-Stage Plunger system increases gas and liquids production by staging the well. This is done by moving part of your energy source under each stage. By staging the well, the fluid load is lifted to a shallower depth.
PIT Solid Ring/Spiral plungers are made out of high performance alloys to allow for economical, low maitenance equipment. They can have solid or hollow centers and are best suited in wells with associated paraffin or scale production. 4140 steel or 17-4 stainless option.
The Ultraseal Plunger has a HNBR rubber Ultra Seal attached to the body of the plunger between interlocking tabs under the pads. The interlocking pads serve as a protector to the Ultra Seal which decreases gas slippage under the pads. This results in less fluid "fallback" during the plunger cycle to the surface, which allows the plunger to make a run on less gas pressure. Offered in single or dual pad design.
The PIT Brush Plunger has a flexible brush spirally wound onto a solid mandrel constructed with under cuts, ensuring de-scaling of the tubing. Brush plungers are used for sand, coal fines and tubing irregularities. PIT Brush Plungers are built with durable alloy steel; brush element is a stiff, heat resistant, durable nylon material.
Designed to fall at high speeds, similar to a PaceMaker, but does not require as much flow time at surface to separate a secondary piece. This tool is designed as an intermediate step between PaceMaker candidate wells and Conventional Plunger candidiate wells. The Rapid Drop Plunger requires no additional equipment on surface to adapt the well for this application and can run in wells with existing subsurface equipment. These plungers are built with heat treated steel. It is recommended that the Bottom Hole Spring have a spring rate of at least 300lbs per inch to handle dry landings.
The Skirted Plunger is PIT's new and improved 4 pad design from flow modeling. It's increased seal and overlapping design reduces gas and liquid bypass as well as improves pad strength. Offered in single, dual and triple pad design.
The Venturi Plunger is a hollow core plunger with a 1.5" internal GS grab. A pressure differential is created across the orifice while the plunger is rising causing an accelerated flow regime inside the tool. The accelerated flow regime interacts via the exit of the tool "helping lift." The upper chamber is at a lower pressure than the lower chamber and the accelerated flow through the orifice creates hydrodynamic lift. The upper chamber acts as a mixing chamber, where gas and liquid are intensely mixed, creating a "traveling gas lift valve" effect. Exclusive Canadian Distributor partnered with T-RAM